Since pumps for above grounds only come as 120V, they all have standard three-prong plug cords attached to them. So due to these pumps having standard cords on them, the easiest way to get power to your pool is to use an extension cord connected to some outlet from the house.

Is a pool pump 110 or 220?

Pool pumps are wired to run on 110V or 220V. Dual speed pump motors can work on either voltage while single speed pumps are more likely to be wired specifically for 110V or 220V. In general, the smallest pumps will be wired for 110V, while the largest pumps are wired for 220V.

Can you run a pool pump off an extension cord?

Running your pump with an extension cord voids the warranty in most cases. Running the pool pump motor with an extension cord that is not adequately paired for the filters power will damage the motor. At times, pool owners, however, use extension cords in lieu of a costly job to bury a power line beneath the ground.

What power does a pool need?

Consequently, in-ground pool pumps require 240 volts. You wont be able to plug them into any old outlet on the inside or outside of your house. Above ground pool pumps, on the other hand, run on 120 volts. This means they could be plugged into a regular electrical outlet.

How many volts are pool pumps?

Most aboveground pool pumps use 115V, and most inground pumps use 230V; but it can be different. If your pump plugs into an 3 prong outlet, chances are its 115V. Your motor label will tell you if your pump is 115V, 115V/230V or 230V.

Can pool pump get wet?

Yes, pumps are made to function outside and will get wet from the weather with no real problems. There is a problem, however, when poor drainage causes standing water from storms to linger around the motor. In short, the motor is not made to function sitting in a puddle of water.

How many amps does a pool pump require?

A typical above ground pool pump will require a 20-amp breaker and use #12 gauge wire to deliver the electricity.