How do I connect the ice maker to my sink?

5:116:53Hooking up a refrigerator ice maker to a kitchen sink - YouTubeYouTubeStart of suggested clipEnd of suggested clipLine. On this braided line here. Its got little nuts in and bushings at the end of it so once youMoreLine. On this braided line here. Its got little nuts in and bushings at the end of it so once you tighten it up you want to make sure you dont tighten it so tight that its going to leak.

Do you hook up the ice maker with hot or cold water?

It should be piped in cold. Re: Ice Maker Water Line, hot or cold? Their reasoning may be that hot water will give better looking cubes than raw cold water, but it will be harder on the inlet valves and the freezer will have to work harder to cool the water down before freezing it.

Can I connect my fridge to my sink?

Thread the water line, included in the ice maker installation kit, from the area behind the refrigerator to beneath the sink. Leave the excess water line behind the refrigerator. Turn on the cold water faucet to drain any water left in the supply line.

Does hot water freeze faster than cold?

If the water is initially hot, cooled water at the bottom is denser than the hot water at the top, so no convection will occur and the bottom part will start freezing while the top is still warm. This effect, combined with the evaporation effect, may make hot water freeze faster than cold water in some cases.

What can I use instead of a saddle valve?

Tip. A similarly DIY-friendly but more reliable alternative to a saddle valve is a push-fit tee connector designed for ice makers and water dispensers. You install these by cutting out a short section of pipe and installing the tee right into the water line, then you add the small supply line leading to the appliance.

How do you run water from a sink to a refrigerator?

The valve connected to the right side of the faucet is the cold water supply line. Turn the cold water on the supply line clockwise to close it. Attach a 5/16-inch drill bit to your drill. Drill holes in the base cabinet walls to route the water line from beneath the sink to the rear of the refrigerator.